Search found 24 matches

Hi Will,

The CCS CAN dev kit that I have comes with the 3 pin male header for CAN High, CAN Low, and Ground.

In my development, I only use two things for the CAN connection. The official Dsub9 ...

Hi Lotusx,

Thank you very much for the update. I will try it out! Very Happy

Hi Lotusx,

thank you very much, I will have a look at it. Very Happy

Hi,

I am looking to do the same thing. There are many things that I still do not understand after I read AN247 document and many topics on this forum.

If anyone could confirm that it works or/an ...

ok, my bad apparently the 18F458 and 18F4580 is quite different for ADC pin and value. Confused

Sorry about posting silly question. Sad

Hi,

Has anyone come across with the read_adc() issue using ex_can_ccs_a.c file on the CCS CAN bus demo board?

I have my CAN stuff working for both node a and b (I took node c and d out because I ...

Hi,

I'm not an expert here but you can post your code here and there will be someone to look at it e.g. PCM programmer. I will help if I know anything. Very Happy

Cheers,

Yes, it is. I have my PIC program like this.

#include <16F876A.h>
#device ADC=10
#fuses HS,NOPROTECT,NOLVP,NOWDT
#use delay(clock=2500000)
#use rs232(baud=9600, xmit=PIN_C6, r ...

Hi,

The chip on the board looks ok as well as the joints on the RS-232.
However, strange thing did happen when I open up the PICkit 2 Programmer.
The PIC works every time I open that program. I d ...

Hi,

My compiler version is 4.093.
Do you need the circuit diagram? I can upload it on the forum.

Hi,

The pin diagram below shows how the pins on CCS CAN bus demo board are connected.

http://img251.imageshack.us/img251/5711/pinconnection.jpg

CS -> RB1
SI -> RC1
SO -> RC0
SCLK ...

Hi,

I did for the mcp2510_init() function and it didn't pass through the first function.

void mcp2510_init(void) {
printf("\r\n 10"); <---------- St ...

Hi,

I did as you suggested (also changed <> to "" for #include "can-mcp2510.c").

This is what I receive on the hyper terminal

hello?
1
.

and below is the pa ...

Hi,

I'm using the CCS CAN bus demo board and the example code that comes with it.

I reprogram node B (16F876A) because I am going to use something similar to this setup with the example code EX1 ...

Hi,

I got the CCS CAN bus demo kit afterward so that I know that there is no problem with the hardware side before I implement the protocol to my own software and hardware.

I will let you know h ...