Search found 7 matches

Thank you libor for this valuable explanation about the electronics side.

Would you suggest any Diode such as 4004? Or 4008 or signal diodes?

The board itself is going to act as a master co ...

Hi libor,

Thank you for your input. Yes, the plan is to use lithium batteries.

I am more into software than hardware, especially electronics; are the diodes prevent both of them being used beca ...

Hi all,

Is there any IC which handles automatic switching power supply from a battery if the master power input detected failed?

I am trying to have a final result such as:

PIC and whole boar ...

Hi all,

Sorry if this is repeated question/answer:

Using the code provided here (highly appreciated) by dvsoft, I can communicate with the CF card, the Identify function returns correct data:
...

Hi all,

Does it make more sense to switch the design to CANBus rather than RS485? The PICs can be replaced with pin to pin compatible 18F258 which has CANbus support? Any advice on which is more ...

Hi Rob

Thanx for your input.

is RS485.c code that comes with CCS can be used directly even though the header of the file says address can be 1 to 33 , while using the MAX1483 means address can b ...

Hi all,

I was wondering if the RS485.c will be compatible with transceivers such as MAX1483 (running half duplex, two wire bus and datasheet mention it can be used up to 256 nodes on the same bus) ...