Search found 13 matches

Hello Eduardo,

Just one question about nRF24L01P.h:
Don't miss something in your code? (in red in my quote)

enum RF24_RF_SETUP { //RF Setup Register
CONT_WAVE =0b10000000, //(0)Enable ...

Hi all,

PCM Programmer, your code don't work for me.
From 16F/1823 datasheet: Global WPUEN bit of the OPTION register must be cleared for individual pull-ups to be enabled.
need to change it like ...

Just find what's wrong with my timer.... Laughing

have to change
setup_timer_1(T1_INTERNAL | RTCC_DIV_2);

with

setup_timer_1(T1_INTERNAL | T1_DIV_BY_2);

just try something...change my values from unsigned INT8 and unsigned INT16 into signed INT8 and signed INT16 and the 2 leds blink together.... Shocked

Hi all,

i'm in progress to work on a small new design (real pcb) using a Pic 16F1823 with CCS 4.114.

Have an issue with delay_ms (does not work), so try to use timer1 to blink a pair of led.
...

Hi all,

Because I will use MRF24J40 in some weeks, I start to write a driver for this chipboard, so here is a first piece of code (the low level routines which read and write to the MRF24J40 via th ...

Sorry, I've no test this code because no hardware for the moment.
The design of the pcb for the capacitive touch is done but not manufactured.

Regards,
Franck

Here is a code that should be work now! (not tested on real hardware)

It is possible to configure output level when a pad is touched:
- high output level when OUT_POLARITY pin is set to GND.(stand ...

PCM programmer,

Thank you very much for your answer.
I updated my CCS release and it's now OK about VCAP fuse.

About interrupt, I will check your solution using #int_default.

Franck Wink

Hi all,

inspired by Microchip Mtouch app. notes and especially AN1171 and Nuts&volt technical paper (june 2008), I start to write a driver for the Build-in Mtouch µC 16F722, 16F723 and 16F726. ...

Robert,

Thank you for your feed-back, I keep in mind your solution and will finish my hardware design. I'll let you know the result in some weeks.

regards,
Franck

Hi all,

here is a driver which contains a set of useful routines for use with a Noritake-Itron GU112X16-7806 graphical Vacuum Fluorescent Display (VFD)in parallel interface.

//---------------- ...

Hi all,

Here is a code for driving a MAXIM DALLAS MAX6650/MAX6651.
It's a fan speed regulator and monitor with SMBUS/I2C bus interface.

//***************************************************** ...