 |
 |
 FAQ Forum Help Official CCS Support  Search
 Register
 Profile  Log in to check your private messages  Log in
|
CCS does not monitor this forum on a regular basis. Please do not post bug reports on this forum. Send them to CCS Technical Support |
| Search found 5 matches |
| Author | Message |
|---|---|
 Topic: Converting ascii hex to decimal |
|
| Jomile Replies: 2 Views: 7271 |
 Forum: General CCS C Discussion Posted: Thu Nov 08, 2007 10:52 pm Subject: Converting ascii hex to decimal |
| Thanks PCM programmer, that did it. I was not aware of the 'L' to do 16-bit math. Much appreciation | |
| Topic: Converting ascii hex to decimal |
|
| Jomile Replies: 2 Views: 7271 |
Forum: General CCS C Discussion Posted: Thu Nov 08, 2007 3:08 pm Subject: Converting ascii hex to decimal |
| I found some example code that converts ascii to decimal and it works well. If someone could explain why the code below doesnt I would appreciate it
I wanted to convert a 3 digit number to decimal ... |
|
| Topic: ADC-- RA0 has a non-zero voltage on it |
|
| Jomile Replies: 1 Views: 3252 |
Forum: General CCS C Discussion Posted: Wed Nov 07, 2007 3:03 pm Subject: ADC-- RA0 has a non-zero voltage on it |
| I am using the A port for ADC (16F877A). When i use RA1 i have no problem but for some reason I am having issues with RA0. I measured the voltage on the pin and it is 2.14V (open). I tried two chip ... | |
| Topic: Receiving RS-232 Data From HyperTerminal (16F877A) |
|
| Jomile Replies: 3 Views: 6377 |
Forum: General CCS C Discussion Posted: Wed Nov 07, 2007 12:09 pm Subject: Receiving RS-232 Data From HyperTerminal (16F877A) |
| Thanks for the code.
I implemented it and still had the same problem. It turned out that the development board that I am using had a resistor between the max chip and the port. I shorted it out and ... |
|
| Topic: Receiving RS-232 Data From HyperTerminal (16F877A) |
|
| Jomile Replies: 3 Views: 6377 |
Forum: General CCS C Discussion Posted: Tue Nov 06, 2007 4:56 pm Subject: Receiving RS-232 Data From HyperTerminal (16F877A) |
| Hello,
I have an 16F877A and MAX233 chip that i am using to communicate with a computer (hyperterminal). I have no problem sending data to the computer using printf. The problem I have is when ... |
|
All times are GMT - 6 Hours |
Powered by phpBB © 2001, 2005 phpBB Group