Search found 75 matches

Hi,

I have found the cause of the problem. There was a 0.1uF decoupling capacitor on the MCLR pin. When I removed it, the ICD works for programming and as a debugger within PCWH.

Hi,

Thanks for replying. I bought one about a month ago and using V4.023 CCSLOAD, I had no problems programming the flash memory and EEPROM of 18F6720 and 18F2620 using battery and dc supply in tu ...

Hi PCM Programmer,

Thank you very much for your comments. You have saved me a lot of time. I really appreciated your help. Laughing

As you said do a full erase which I did, but couldn't do it fo ...

In 6, the simple program is a separate program. Thanks.

Hi,

1. I have an 18F6720 hex file which can be programmed into a 6720 with no problems using ICD-S40 or PM3 programmer. The 6720 works.

2. I then use the same set of source files from 1 and made ...

Hi, Did you manage to program the flash without programming the data EEPROM? Thanks.

Hi, I would like to buy one. Can someone give me some answers.

1. Can the Load-n-Go be able to program the flash, EEPROM and configuration fuses independently?

eg1. Program just flash and confi ...

Hi FvM,

Thanks for your help. Yes I did a search and there are still many bugs. I think it would be best not to choose it at present.

Hi Ttelmah,

Thank you for your comments. Yes, you made an interesting comment on code protection of the hex file. I have removed it and now I'm getting some minor differences in CONFIG bits between ...

Hi, Thank you for your comments. I didn't know Rowley provide C compilers and tools for ARM devices. They are not listed in the ST website. One thing I notice is that they don't provide a user forum f ...

Hi, I have PCWH V3.249 and been using it for a few years on PIC16F and 18F devices. I’m contemplating buying PCWHD to be used on PIC24 devices because it has a bigger flash memory (max 256KB) for ne ...

I have an old hex file for a PIC18F6720 target but no source files. As this chip is becoming old, I’m trying to replace it with a PIC18F6722 target because it is cheaper.

How do I modify my old ...

Sorry, the second last paragraph should read:

Also, I have an ICD-S40 (serial) and this programs hex files onto the same target using CCSLOAD and operates the debugger in PCWH without any problems. ...

Hi, I have the following:

PCWH: V3.249
ICD-U40: firmware V2.62, hardware Rev 4
CCSLOAD: V4.022

I have programmed a hex file into the target (PIC18F2620) using CCSLOAD successfully. However, w ...

Thanks to both Ttelmah and FvM. I have tried the MPLAB and CCS methods, and I agree with Ttelmah that the MPLAB method is much easier to edit the ASCII text.