 |
 |
 FAQ Forum Help Official CCS Support  Search
 Register
 Profile  Log in to check your private messages  Log in
|
CCS does not monitor this forum on a regular basis. Please do not post bug reports on this forum. Send them to CCS Technical Support |
| Search found 3 matches |
| Author | Message |
|---|---|
 Topic: I2C Slave not getting Interrupt |
|
| btpolo1 Replies: 2 Views: 15643 |
 Forum: General CCS C Discussion Posted: Wed Oct 05, 2016 10:41 am Subject: I2C Slave not getting Interrupt |
| I'm using a 18F67J94 and trying to connect it to an ARM using I2C. The ARM is the master device and the PIC is the slave. Both are running at 3.3 V and the PIC has 4.7 K pull-up resistors. In addit ... | |
| Topic: Problem configuring PWM on 18F67J94 |
|
| btpolo1 Replies: 2 Views: 13777 |
Forum: General CCS C Discussion Posted: Thu Sep 29, 2016 10:42 am Subject: Problem configuring PWM on 18F67J94 |
| Okay I was able to figure it out. I finally determined how to decode Table 11-14 in the chip documentation.
I did the following: #pin_select P1C=PIN_D1 #pin_select P1B=PIN_D2 Thanks. |
|
| Topic: Problem configuring PWM on 18F67J94 |
|
| btpolo1 Replies: 2 Views: 13777 |
Forum: General CCS C Discussion Posted: Wed Sep 28, 2016 2:49 pm Subject: Problem configuring PWM on 18F67J94 |
| We are using the 18F67J94 for a project, and we would like to do PWM on pins RD1 and RD2. The PWM is separate for each pin. When we try to build our software, I keep getting "Option invalid :: ... | |
All times are GMT - 6 Hours |
Powered by phpBB © 2001, 2005 phpBB Group