Search found 10 matches

I am trying to set up a counter that will count greater than 255, everything I have tried has failed. I have defined my variable as
long timer_delay

this should be a 16bit number correct?, so I do ...

Thanks, the printf, did the trick. I didn't know you could do that, I have a lot to learn.

Thanks again,

Croc4

I have a project that I'm stuck on. I have a pic (16F628A) that I am using as a I2C master, I'm bit banging the protocol. I also have a ADC connected to the pic. The goal is to read the ADC and then d ...

you may have an issue with your osc freq and the way you declare your delay (#USE delay(xxxxxx)), if this number is different from the actual osc speed I have seen it skew the delay_us/ms commands qui ...

I had the same problem until I turned off the analog ports
// Turn off the ADC
setup_adc_ports(NO_ANALOGS);

try this and see if things get better

found the problem, brain fart!!!!! I was using 7 bit addressing and not eight, duh!

I set the device up as addr 0x52, and sending in 0xA4 (which translates to 0x52 on the bus), once I set it to 0xA ...

thanks for that thread, but I'm not using the setup_spi() routine, so that can't be it, well it seems that the tools that I am using should support HW I2C so maybe I have mad a bone head mistake, I'll ...

Just checked it and it was marked as "true" for I2C slave....

I have PCWH I believe (no near my dev system at the moment), I can't point to a part of the code that is failing, I don't think that it even gets that far. Here is how I understand it, and I could be ...

anybody know, I don't want to upgrade if I don't have to and at the moment
my code for talking to a slave 16F88 is not working, the slave is not acking the address, pretty basic problem I know, but ...