Search found 10 matches

I'm using PIC18F27Q10 and PCWHD 5.095.

In my program I call restart_cause() to find out what caused the last restart. Right now it is returning 0x2F. The problem is that restart_cause() returns onl ...

I'm having the same problem today. I set the loader program to not erase the data EEPROM and it erases it anyway.

I had had this problem with earlier versions of the ICD program, and I never resol ...

Thank you for the guidance, folks.

Working or not, I removed all recursive function calls as described above. However, I still have the problem of interrupts getting disabled after several minutes ...

Thank you Ttelmah for the advice. I haven't found anything wrong in the interrupt yet, but I may have found the problem in main(). My printf actually itself calls printf:

VOID AppendChecksum( ...

I am using CCS 3.249 (having read that it is the most stable) to program a PIC18F2420, crystal clocked at 20 Mhz.

My program sets up a single periodic interrupt to perform a high priority polling t ...

:=I have an application with a PIC16F877 acting as a
My project is Single Master/Multiple Slave using the 9-bit command mode with the F877. I had trouble tri-stating the slave UART TX pins appropri ...

I'm having a similar problem - with the PIC18F6527.

When I program the chip using the ICD-U40, my program works correctly, but the ICD.exe program reports that verification failed, and nothing tha ...

I want to use pin A6 for IO,
on the PIC18F258.

Inside PIC18F258.h, there is:

#define PIN_A0 31744
#define PIN_A1 31745
#define PIN_A2 31746
#define PIN_A3 31747
#define PIN_A4 31748
# ...

I used that compass, and I'd send you my code but I seem to have deleted it.

I remember the only tricky thing was the following:

I used the compiler's "spi_write" and "spi_read" except the polar ...

I have been working with the PIC18F258, and have encountered intermittent "noise" on the CAN bus which I think is caused by the PIC.

I find out about this from my PC utility program "PCANView USB" ...