Search found 24 matches

After few months of frustrations trying to get my project done, I found some problem within MPLAB itself. I was working with three projects at the same time keeping them in separate folders. Some of t ...

I don't understand your bootloader layout. If the loader is located starting from 0x5000, how can it call flash write code at 0x346 (the main application area).
Thank you for reply. I added "def ...

It is my first project with “C” and CCS. Application is very complex system and after 4 month everything is working just fine. Before releasing this product I have to implement the bootloader, so ...

I found the problem. Well… at least one of the problems and I do not know how it was working before and pass all beta tests?!
In device configuration files, under “Timer Functions” they have:
...

Thank you. I just updated my compiler, but for some reason I can’t get any of my codes working at all. After some tweaking code compiles, but does not run correctly. Will try to figure out what is g ...

I traced the problem to the interrupts. They are quit working at some point. For example I am using 50mS Timer-4 Interrupt, were I do have counters to do some routines in 500mS and 1000Sec. with [Slee ...

Recently I finished an application for PIC24FJ32GA002. Since memory used only 30~35% I decided to approve PIC24FJ16GA002 for the production.
Now, when I am trying to run the code on 16K device, every ...

I am using MPLAB IDE v8.15, PCD v4.083, for PIC24FJ32GA004.
After compilation the following libraries get’s attached to the project:
Ctype.h; stddef.h; stdlib.h; string.h
In my code I am not incl ...

As said, the code page size is 0x400 words (or 0x200 instructions). Due to the 24 bit instructions size, there is a dummy byte included in each double-word, but you don't have to care for it, except w ...

OK, now it is more confusing. Checking the PIC’s datasheet (page 41 With RTSP, the user may write program memory data in blocks of 64 instructions (192 bytes) at a time, and erase program memory in ...

You right, I forgot about 16+8 word configuration. Does that mean erasable block of memory address will be 0x0000~0x07FF; 0x0800~0x15FF and so on?
In this case I can’t write for example in the midd ...

In my application I am using two devices. PC connected to the station via USB. I am using FTDI (232RL) with PIC24FJ32-004 to host the remote devices via custom 1-wire protocol. In remote devices I am ...

I tried your code with a 24FJ128GA010 and it has correct serial output.
Thus I think it's most likely a device specific issue.
Thank you for doing it. In this case I better order another set of cont ...

You had said earlier that there are no erratas on this problem.
In fact, in the Rev. A3 silicon there are many erratas on BRGH,
autobaud, etc.
http://ww1.microchip.com/downloads/en/DeviceDoc/80316 ...

Yes, when the software UART works correct, you can expect that the oscillator frequency is basically O.K.

I found, that with clock=32000000 the baud generator is initialized somewhat strange by the ...