Search found 9 matches

I must have stared at the manual for a half an hour before I wrote this post... can't believe I didn't see there wasn't a semi-colon.

Thanks

Compiler: PCWH 4.024
Part #: PIC16F913
Oscillator: 20MHZ

Why when I try to use the #bit directive multiple times inside a function, the compiler gives me the error "A numeric expression mus ...

The L is needed to tell the compiler you want a 10-bit PWM... otherwise it will assume 8-bit.

From the equations I posted earlier, a 50% duty cycle needs a value of 125... set_pwm1_duty(125);

1 ...

I am using a PIC16F913. Where is the hardware interrupt address?

From the LST file:
.................... #int_TIMER1
.................... void TIMER1_isr(void) //setup to interrupt ev ...

Where in the LST file can you see the instructions required to get into an interrupt and the instructions required to get out of an interrupt? I want to calculate the amount of time my interrupt rout ...

What does the upper case L do?

The duty value is a fraction of the middle number in setup_timer_2().
Look at the example program.

31/124 = 25% duty cycle

62/124 = 50% duty cycle

In your modified code, you have picked 249 ...

I am using compiler version PCWH 4.020

I am trying to set up the PIC16F913 to output a PWM. When I use the CCS PIC Wizard and set up CCP1 as a PWM, it says the PWM output is on pin C2. However, i ...

Is there a document which outlines how much time it takes to execute every 'C' instruction.

In the datasheet for the PIC16F913, it states that the Instruction Cycle Time equals four divided by the ...