 |
 |
 FAQ Forum Help Official CCS Support  Search
 Register
 Profile  Log in to check your private messages  Log in
|
CCS does not monitor this forum on a regular basis. Please do not post bug reports on this forum. Send them to CCS Technical Support |
| Search found 4 matches |
| Author | Message |
|---|---|
 Topic: CAN problem with dspic30f6010A |
|
| mitice Replies: 1 Views: 3524 |
 Forum: General CCS C Discussion Posted: Wed Nov 30, 2011 12:11 am Subject: CAN problem with dspic30f6010A |
| I try to operate in loop-back mode. It still didn't get the can message. | |
| Topic: CAN problem with dspic30f6010A |
|
| mitice Replies: 1 Views: 3524 |
Forum: General CCS C Discussion Posted: Thu Nov 24, 2011 5:09 am Subject: CAN problem with dspic30f6010A |
| Hi everyone. I'm using dspic30f6010a with 10Mhz, and I set the Bit rate 500K. Now I encounter some problem that I can transmit data but not receive data. The following is my code. Could someone tell ... | |
| Topic: About "Baud rate out of range" |
|
| mitice Replies: 6 Views: 10230 |
Forum: General CCS C Discussion Posted: Mon Sep 26, 2011 9:08 am Subject: About "Baud rate out of range" |
| Ttelmah,
Thanks a lot for your answer. If I want this pic work under these condition: UART baurd rate:115.2K & CAN BUS bit rate 500K. What frequency of the master clock you recommend ? |
|
| Topic: About "Baud rate out of range" |
|
| mitice Replies: 6 Views: 10230 |
Forum: General CCS C Discussion Posted: Mon Sep 26, 2011 4:28 am Subject: About "Baud rate out of range" |
| HI, everyone
I encountered a problem about setting the baud rate of rs232. code: #fuse EC #device *=16 ADC=12 #use delay(clock=10Mhz) #use I2C(SLAVE, SDA=PIN_G3, SCL=PIN_G2 ,addr ... |
|
All times are GMT - 6 Hours |
Powered by phpBB © 2001, 2005 phpBB Group