Search found 12 matches

3.221

Sorry.

Remove the T2_INTERNAL constant. The correct setup_timer_2() calls should be :

setup_timer_2(T2_DISABLED|T2_DIV_BY_1,29,1);

and

setup_timer_2(T2_DIV_BY_1,29,1);

I'm trying to get the PWMs working with Timer4 on a PIC18F6720 instead of Timer2. Here's my problem...

If I use the following code snippet, I cannot get PWM5 to run

setup_timer_0(RTCC_INTE ...

To make the cursor show up on HD44780 or compatible LCD modules, I used

lcd_send_byte(0, 0x0F); // Send Command to Show Cursor

To hide the cursor, use the following:

lcd_send_by ...

Not quite sure what a character syntax error is, but the definitions you made for the channels in binary look a little off. I was under the impression that binary numbers were written like 0b11010101 ...

Thanks for responding.

It tried what you said, by adding those lines, and putting a tx_on() before my transmission routine and tx_break() at the end of the routine as well as in main(), but it didn ...

I have a big problem that hopefuly someone here can help with. I am using the 3.185 compiler targetting a PIC18F452. In the main header file for my application, I have the following line:

#use rs ...

In case you don't know, the only real difference between IEEE-754 and the Microchip floating point numbers is where the sign bit resides. Here is some code I wrote to do the conversion, though it [spam] ...

It might help to know what type of timing error you can tolerate. If you are reading every hour for 1000 hours, then a couple of seconds either way may not make a difference. If that's the key, you ...

I finally seem to have found a solution to my problem. It seems if I add a typecast for RawValue to a float in the third line from the end, the calculation for Correct.fValue. This line would then l ...

If I understand correctly, you want to configure the MAX3100. I've used the MAX3110 before (close to the same part).

Note that spi_write() only uses 8-bit ints, so you need multiple writes to get ...

Hello,

I am using the 3.185 compiler, and have run into a small problem with a function I have written. The problematic function, called correct_adc_value(), is given below:

int32 correct_adc_v ...