Search found 35 matches

Hi i have read post of all the related links
but couldnt find the solution.
Someone says that place pull ups on row pins. Some say on column pins but i need code for pull down column pins
my keypa ...

hi
in timeout also consider the time after which your connection is terminated by other side. Make this your limiting factor of socket time out as you are not going to distributed system so no questi ...

hi
i am using kbd.c for a 3X4 keypad. And it is working when i pull up the row pins. But i can only pull up column pins. So what modification in kbd.c I need to get it working with pulled up column p ...

problem solved, I was using same UART for other application
Very Happy

hi
I am using tiny bootloader for my application i have followed all the steps of the post

The device i am using is 18F4620 with clock of 20MHz
and the hex file in the directory \picsource\18f
t ...

check the data-sheet of your micro-controller because i think that 9600 is the maximum baud you can achieve using 20Mhz clock. There is a formulae for maximum baud rate dependent on frequency.
I thin ...

Hi
My question is this that what is difference between SPI and UART.
In what applications we will use SPI and where we will use UART from design point of view.
Smile

when i declare the index variable as
static unsigned int16 index;
the index was having an overflow.
everything worked fine..

Hi following is my hardware info
#include <18F4620.h>
#use delay(clock=20000000)
#fuses HS, NOWDT, NOLVP, NODEBUG

#use rs232(baud=9600,xmit=PIN_C6,rcv=PIN_C7,bits=8)
the ...

Hi i have limited knowledge about html. My question is.
Is there any way by which i can write the HTML request to server and when i send it the response is displayed. This is at pure hardware level. ...

Thanks
I understand..
May be the quality of crystal might be the reason
Any ways Thanks to PCM and all fellows.
Smile

Its not working. Everything is working except rs232. Sad

Thank you PCM
TCP/IP stack file ccstcpip.h
contains the code (i am using it)

#if STACK_USE_CCS_PICENS
#include <18F4620.h>
#use delay(clock=40000000)
#fuses H4, NOWDT, NOLVP, NO ...

My application is configured at 40Mhz H4 configuration, above code is sample for the rs232 problem. Is there any way to fix the rs232 communication keeping same settings (40Mhz). Confused

use
read_program_eeprom(address);
keep track of pos variable and use it to retrieve data from eeprom then send the result to PC via rs232 using printf function
look both
read_program_eeprom(addre ...