Search found 9 matches

I can not believe. After two days crazy, says the solution is as PCM programmer, I have taken instruction FORCE_HW and work perfectly.

Many thanks to both, you have helped me a lot.

Regards

Thank you very much for your time.

I have corrected the problem of sending the stop and reset the data.

The device I use is to TC74 but 5 volts, not 3.3, it tells you forgive me wrong, the datas ...

Thanks for the reply Ttelmah.

In the datasheet, (#include <16F88.h>
#FUSES NOWDT,INTRC_IO,PUT,NOMCLR,NOPROTECT,NOCPD,NOBROWNOUT,IESO,FCMEN,NOLVP,NODEBUG,NOWRT
#use delay(clock=8000000&# ...

Hello,

First apologize for my English because I am not native.

I'm trying to read the temperature of a TC74, based on the examples on this website, but I can not get it.

I use Proteus for the ...

It works!!! Laughing

Thank you very much everyone !!!!! At the end with your advice and get directions program has worked.

Also find information on this website, where you can see the code ...

Ok, sorry.

Here is the translated code, I hope to be better.

The pull-up resistors are integrated in the device itself, have a value of 2k2.

Thanks for the advice.

int t;
int datos[6& ...

hello again!

Thanks to your help, I have working examples with i2c, but the program still works fine.

According to specifications of this website:

i2c_start();
i2c_write(0xA5 ...

Thank you very much.

I'll try the settings and then I tell you.

Hello!

I'm trying to read an I2C device, exactly one of the Wii Nunchuk, to get data from your accelerometers, but no way to compile the following code.

#include <16f88.h> //p ...