Search found 64 matches

Hi.
I have folowed this thread:

http://www.ccsinfo.com/forum/viewtopic.php?t=29216&highlight=nmake

For debug I use Proteus, I don't use hardware debug... For this purpose I'm using a lot of ...

I alwayas use a third party IDE. In fact I use Micr***t Visual Studio as IDE.
You can organize code the best with this IDE. The only draw back is the compiler output format, that is not compatible wi ...

I wish to be more generic like:
trace("This is debug value no. %u with address %u", value, address);
trace("Just a line");
trace("Three numbers: %u, ...

A macro.
trace("Something %d, else %Ld", x, y);
that in release just won't do anything...

Hi all.
Can anybody point me to way of doing printf in debug version with a macro?
The same macro in "release" version would do nothing?
It's possible do do this with CCS C?
Thank you.

Thanks!
I will try your solution.

Hi everyone.
I have a small question.
I need to make an array of structs.
MY_STRUCT_TYPE array_of_structs[2];
typedef struct
{
UNSIGNED_8 member_1;
UNSIGNED_16 member_2;
...

Hi all. I'll probably be a little off topic. My apologies for that.
I want to know in what state the pins RTS and CTS are active.
Let's assume my MCU is DTE.
DCE waits for RTS till data can be send ...

Hi again.
I have solved the problem by replacing PIC18F4525 with a PIC18F452.
I don't know what was happening on 4535 but now all works fine.

Clock source XTAL 20MHz.
Fuse set to HS.
#use rs232( baud=19200,parity=N,xmit=PIN_C6,rcv=PIN_C7,bits=8, stream=GSM )
#use rs232( baud=9800,parity=N,xmit=PIN_A0,rcv=PIN_A1,bits=8, stream ...

Another interesting thing is that I'm trying to mask the received character with 0b01111111:
Code:
ReceiveBuffer
You are using a software UART to transmit chars to your PC.
If an interrupt occ ...

Hi.
I'm controlling the GSM with RTS. I keep RTS in disable state till I'm ready to receive the string.
I have found a nice solution tough.
I'm using RDA(I use interrupts as much as I can:)) to rec ...

Thanks.
I'm starting the timer after every received character since what I'm trying to do is t receive the full response from a GSM module.
I'll try out your solution.
Thanks again.

Hi again.
I have this weird problem.
I'm communicating with a GSM module.
I receive a weird character. Almost all the time this bad character is 4th in a string.
Example:
String that should be re ...

Hi all.
I' trying to read the response from one GSM module.
On my PC I'm getting the following answers:
Command: AT+CMEE=2 ( 41 54 2b 43 4d 45 45 3d 32 0d)
Answer: OK (0d 0a 4f 4b 0d 0a)

Comman ...