Water Level Sensor

[faizal117]

Hello,

I want to ask about the water level sensor..

what type of the sensor is suitable for water level measurement?

thank you

[hayee]

You can develop your own simple water level sensor at home, if no special type of sensor is required in your scheme. I can give you an idea how to make this and connect it to microcontroller but how can I upload a picture in the post?

[necati]

http://njhurst.com/electronics/watersensor/

[husam]

hi ,
You can use ultrasonic sensor, check this site
http://www.sparkfun.com/commerce/advanced_search_result.php?keywords=ultrasonic&search_section=products

[Ttelmah]

There are as many different types of water level sensor, as days in a month.
What is best, depends on a suite of factors:
Water in a tank, or open.
Likely range of movement.
Environment.
Accuracy needed.
Speed.
Flow rates, and likely turbulence.
etc...

I have used systems ranging from simple floats, with a cord operating a potentiometer, through versions with linear optical scales, onto capacitive versions (you can get fully sealed versions of the unit mentioned by an earlier poster), ultrasonic, laser reflection, pressure sensors in a tube, etc., etc..

You need to specify the conditions involved to get any real idea of what can be done...

Best Wishes

[faizal117]

hayee
PostPosted: Sat Mar 06, 2010 3:29 am Post subject:
You can develop your own simple water level sensor at home, if no special type of sensor is required in your scheme. I can give you an idea how to make this and connect it to microcontroller but how can I upload a picture in the post?
--------------------------------------------------------------------------------------

thank you for your information hayee...sure u can give your oppinion for my problem...you can send to my email [email protected] and thank you once again have a nice day

[ALPL]

Very simple yet reliable to use is a CD4093-based AD-oscillator/detector-circuit with 2 probes (e.g. metal-wires) installed in a tank, etc. When the liquid level touches both probes one of the CD4093-outputs goes HIGH and switches e.g. a transistor or an opto-coupler which turns ON/OFF a pump, etc. The schematic can easily be found in the internet. Just enter "Water level sensor" and can easily be built.

[faizal117]

Thank you everyone...