ICD-U40 can't "run" after "stop"

phord · Joined: 24 Jul 2005 Posts: 2

My new ICD-U40 seems to work about as well as I remember ICD's working.

But I have this problem (among others): If I run the program and later stop it (Clicking the red "S"), I can't run it again. If I click on Run, it acts like I clicked on Step.

I'm using an 18F4620 and the latest compiler.

Is this just par for the course? Does anyone else see this same problem on the ICD-U40?

Nandini · Joined: 13 Jul 2005 Posts: 15

Please email your code to [email protected] to recreate the issue

phord · Joined: 24 Jul 2005 Posts: 2

This may be caused by my circuit which uses RB6 and RB7 elsewhere. However, it occurs on simple test code which doesn't excercise B6/B7 features otherwise.

I'll experiment some more and send a test case to support.