CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
PWM output drops to zero on CCP1(RC2)

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
Hans Wedemeyer



Joined: 15 Sep 2003
Posts: 226

View user's profile Send private message

PWM output drops to zero on CCP1(RC2)
PostPosted: Fri Dec 09, 2005 11:17 am     Reply with quote
The design uses two PWM outputs CCP1 and CCP5 on the PIC18F6720.
At startup CCP1 on pin RC2 appears and then dies to zero within 1 second, CCP5 works just fine.

I have two units with the same problem. I suspect a chip failure because these two units represent less than 2% of working units using the same code.

The problem reproduces about 99% of the time only on two units.

Has anyone else seen this problem, and are there any defensive measures that can be taken "in code" (cannot change hardware at this time) to prevent this happening.

Thanks
Hans Wedemeyer
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group