CCS :: View topic - Soft RS232

FAQ

Forum Help

Official CCS Support

Profile Log in to check your private messages Log in

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support

Soft RS232

CCS Forum Index -> General CCS C Discussion

View previous topic :: View next topic

Author

Message

Storic

Joined: 03 Dec 2005
Posts: 182
Location: Australia SA

Soft RS232

Posted: Sat Apr 01, 2006 6:42 am

Hi,
Just a note on how I resolved Software RS232, Sending Garbage Characters. I could get the RS232 to work on the built in UART, however when program for software UART, I was receiving Garbage Characters. Confused

Code:

#use rs232(Stream=Wview,baud=9600,xmit=PIN_B7,rcv=PIN_B6,bits=8)

After reprogramming my code under RTOS, I found the RS232 working as expected. I the reprogram back and found that the interrupt had cause this problem. After disabling the interrupt All works Well Rolling Eyes

Code:

#use rs232(Stream=Wview,baud=9600,xmit=PIN_B7,rcv=PIN_B6,bits=8,DISABLE_INTS)

You probly need to add E: in your RS232 The PIC� is Sending Garbage Characters. (To add DISABLE_INTS in your #use rs232 if you are using interrupts) Wink

Andrew
_________________
What has been learnt if you make the same mistake? Wink

Display posts from previous:

	CCS Forum Index -> General CCS C Discussion	All times are GMT - 6 Hours
Page 1 of 1

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum