SPI mode change

[GusA]

I am working with a PIC18F67K22 microcontroller, using the PCWH compiler ver 5.093.
I have a working SPI bus configured as follows:

#use spi (MASTER, SPI1, BAUD=500000, MODE=0, BITS=8, STREAM=SPI_1)

The bus is operational with all spi devices except for one that requires the MODE=1 (IDLE=0 and SAMPLE_FALL). I have not found a library function that can change modes within the program (when communicating with the particular device).

Is there any way, besides using assembly (#asm.....#endasm)?

Thanks!

[GusA]

CCS technical support replied as follows, which BTW I tried and worked fine:

You can do this:

#use spi (MASTER, SPI1, BAUD=100000, MODE=0, BITS=8, STREAM=SPI_1A) #use spi (MASTER, SPI1, BAUD=100000, MODE=1, BITS=8, STREAM=SPI_1B)

Call spi_init() to change the mode and always use the right stream ID for the SPI calls.

[Ttelmah]

Yes, this has been answered here before. Using two (or more) streams.