CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
programming 3.3V parts

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
Ringo42



Joined: 07 May 2004
Posts: 263

View user's profile Send private message

programming 3.3V parts
PostPosted: Sun Oct 19, 2008 9:55 am     Reply with quote
I'm using a 16lf876a and the ICD-U40.
My board has a part (pressure sensor) that will only work at 3.3V. When I connect the programmer to the board doesn't it put 5V on the Vcc line (or require 5V be there)?
I don't want to fry the sensor by accidentally putting 5V on it. How do I program the board?
Thanks
Ringo
_________________
Ringo Davis
FvM



Joined: 27 Aug 2008
Posts: 2337
Location: Germany

View user's profile Send private message

PostPosted: Sun Oct 19, 2008 10:18 am     Reply with quote
ICD-U40 doesn't drive VCC unless you install a jumper inside the case. ICD-U40 should work with a board supply of 3.3V without problems.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group