CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
flex keypad hardware help

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
lasal



Joined: 25 Jan 2012
Posts: 13

View user's profile Send private message

flex keypad hardware help
PostPosted: Mon Jul 09, 2012 3:42 am     Reply with quote
I suppose to use Flex_KBD.C in my application. But i can't understand where i must put the pull up resisters. please can someone tell that where to put pull up(or down) resisters in columns or rows. Please help.

Thank You !!!!!!!!
Ttelmah



Joined: 11 Mar 2010
Posts: 19546

View user's profile Send private message

PostPosted: Mon Jul 09, 2012 4:58 am     Reply with quote
If you look at flex_kbd, you will see it says it is based on kbd.c, with the addition of allowing you to use different pins.
Look at kbd.c, and you will see it says where the resistors are needed.

Best Wishes
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group