CCS :: View topic - PIC 18F67j60 and PWM

CCS C Software and Maintenance Offers

FAQ

Official CCS Support

Profile Log in to check your private messages Log in

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support

PIC 18F67j60 and PWM

CCS Forum Index -> General CCS C Discussion

View previous topic :: View next topic

Author

Message

Requan

Joined: 11 May 2008
Posts: 74

PIC 18F67j60 and PWM

Posted: Tue Jul 03, 2012 6:57 am

Reply with quote

Hi,
I tried to make PWM on Pin E4 (PIC 18F67j60 , 25MHz):

Code:

set_tris_e(0x00);
setup_ccp3(CCP_PWM);
setup_timer_2(T2_DIV_BY_16, 194, 1); //2kHz
set_pwm3_duty(80);

I think i made everything but it doesn't work.
Do you have any hints for me?

Ttelmah

Joined: 11 Mar 2010
Posts: 19540


Posted: Tue Jul 03, 2012 7:23 am

CCP3, in compatiblity mode, on a 67J60, comes out on D1. Best Wishes

Requan

Joined: 11 May 2008
Posts: 74


Posted: Wed Jul 04, 2012 9:33 am

Thanks for help again. Could You also explain me why when i use hardware pin for I2C it worked but when i use pins: E2 and E3 it doesn't work. Should I turn off something?

Requan

Joined: 11 May 2008
Posts: 74


Posted: Thu Jul 12, 2012 2:18 am

I solved this problem: On the beginning i put SDA and SCL in High state.

Display posts from previous:

	CCS Forum Index -> General CCS C Discussion	All times are GMT - 6 Hours
Page 1 of 1

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Powered by phpBB © 2001, 2005 phpBB Group