Assembly code not generated !!!!!

[vinay]

Hi all,

I am programming a PIC16F876A to read/write time/date to a DS1307, using the DS1307.C driver file.
But when I call the functions
ds1307_get_date(DD, MM, YYYY, DofW); //Get date
ds1307_get_time(Hours, Minutes, Seconds); //Get time in main() there is no corresponding assembly code generated in .lst file for that call
Pls help !!!!

Compiler version 4.114[/b]

[temtronic]

We'd have to see your 'main' source code to properly debug.
Have you called ds1307_init ?

I do know the driver works fine,so the problem must be in 'main'.

hth
jay

[vinay]

OOOPS !!!!!
Looks like I was wrong, code was generated.
Found out by noticing the addressess of each assembly code especially when
ds1307_get_date(DD, MM, YYYY, DofW); //Get date
ds1307_get_time(Hours, Minutes, Seconds); //Get time are called.
But these two functions were becoming inline.
(Simply called the functions two to three times in main() and noticed the code memory consumed was increasing substantially).


@temtronic
thanks for your reply !!!!
Much appreciated !!!!