CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
Reset problem in dsPIC33ep512mu810

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
[email protected]



Joined: 28 Jul 2014
Posts: 38

View user's profile Send private message

Reset problem in dsPIC33ep512mu810
PostPosted: Thu Aug 15, 2019 3:13 am     Reply with quote
I am using dsPICc33ep512mu810 to control two ac servo drives. Everything works good. Sometimes if i press reset button the controller stops the job but hangs. I have to press the reset button 2 to 3 times to reset again. this happens around 1 in 4 to 5 resets. Kindly give solution.
temtronic



Joined: 01 Jul 2010
Posts: 9242
Location: Greensville,Ontario

View user's profile Send private message

PostPosted: Thu Aug 15, 2019 4:21 am     Reply with quote
Please post which 'ac servo drive' units you're using.

Some possible( not all...) reasons are
1)noisey 'reset' PB hardware. Without seeing your schematic, it could be contact bounce' or bad levels.

2) the 'ac servo drive' may have certain level/timing parameters that aren't being met.

3) marginal power supply

4) poor EMI protection

5) bad PCB layout/ component choices.

Jay
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group