Mach 3 chip support question

Arizona Chris · Joined: 20 Dec 2014 Posts: 69 Location: Arizona

Hello, we are finally considering purchase of the full $600 version of the compiler to be able to do all the PIC chips. We also use the mach 3 programmer. Can I upgrade for free the list of chips is supports (we have the 2016 version) to be able to do all the chips that the CCS full version includes?

Thanks.

temtronic · Posted: Sat Sep 14, 2019 3:53 pm

You should ask CCS directly as 'CCS does not monitor this forum on a regular basis'...
This is really a place for CCS users to 'ask and tell' about their compilers...

Jay

Ttelmah · Joined: 11 Mar 2010 Posts: 19539

Er. Mach 3 is not a CCS product. Mach X is their unit.
If you mean the Mach X, then this page lists the devices currently
supported:

<http://www.ccsinfo.com/devices.php?page=icddevices>

Beware that though the list does not list them, some chips
seem to need the latest hardware to program without an adapter
board. The units can be adapted to this spec.