Changing Soft Uart Baud

[Sparky]

Hello,

Is it possible to change a soft uart baud while the program is running? I know there is set_uart_speed() but I believe that only works for the hardware uart.

Thanks.

[temtronic]

If you use the 'search' feature here, you should get a couple of hits about setting up 2(or more) use rs232(....) with stream option.

Far easier than the old way of locating the memory location of the baud rate counter and changing it.....!!

[PCM programmer]

[Sparky]

Thank you very much for the help.

I am now using 2 streams with different bauds on the same pins and it works perfectly.