18f4580 PWM config

[Lemosek]

Hello,
I need a PWM on pin P1A(RD4). This is output ECCP.
I don't know how I must configure this module.

I tried something like this:

[Ttelmah]

The ECCP is reverse compatible. To use the default pin, just use:

SETUP_CCP1(CCP_PWM);

Key thing is though, you must have turned off the PSP port:

SETUP_PSP(PSP_DISABLED);

or this will have control of the port pins.

Best Wishes

[Lemosek]

Hello,
Thank You Ttelmah now it's working but I must also change CCP1 to CCP2.

Best regards
R.L.