16F1825 internal 32Mhz

[picprogrammer]

According the datasheet of the 16F1825 it must be possible to set the internal clock to 32mhz 4x8Mhz PLL
However
setup_oscillator(OSC_8MHZ|OSC_INTRC|OSC_PLL_ON,0);
Does not work, pll_on or off no difference. Always off.

Also #FUSES PLL no difference, the 4xPLL stays off in MPlab. When i override the configuration bits no change. So why is internal oscillator and PLL not possible?

In the datasheet: INTOSC – Internal oscillator (31 kHz to 32 MHz).
In figure FIGURE 5-1 shows 8Mhz can be routed to the 4xPLL

[PCM programmer]

Always post your compiler version for a question of this type.

[temtronic]

Section 5.2.2.6 details how the various fuses have to be set to enable the 4XPLL with Internal Oscillator.

I suspect that the fuses are not being setup in the correct sequence but I don't have that chip to confirm what is actually programmed into one.

[Tasark]

Compiler 4.138

I've tried this as well and can only get 8mhz no matter what I try. I'm not sure how to set the FOSC bits that are described in the datasheet. Any help?

[PCM programmer]

[jgschmidt]

I'm currently using this family of processors. Here is my setup for 32MHz internal clock: