Blank disassembly list depending on code

[E_Blue]

I'm using MPLAB IDE v8.92 and CCS v5.048 to generate code for a PIC18F67J50.

I get three results depending on the code, even a single Enter can change the result.

1)I get the full disassembly list code.
2)I get one blank line.
3)I get one line with a single GOTO @cinit1

I search in this forum and see that happen old time ago with an early version of CCS compiler.

https://www.ccsinfo.com/forum/viewtopic.php?p=59447

This bug was solved or still alive until nowadays.

There's any considerations to take to work around this bug?
_________________
Electric Blue

[PCM programmer]

What are your Project / Build Options settings in MPLAB ? In the Debug
section, if I select None or Expanded COD format and compile, it says
"Failed to Load" and gives me a blank Disassembly Listing in the View
menu. If you use COFF format, it should work OK.

[E_Blue]

Yes I'm using COFF format.

The result changes according to the code.
_________________
Electric Blue

[Ttelmah]

I must admit, I have never seen this.

However I always compile _outside_ MPLAB. Don't know why, but it seems much easier to have proper control of the compile process, being confident that MPLAB will not change things, and seeing the compiler error messages directly, rather than having an extra layer that may hide things.

Try the experiment, with code that shows the problem, of compiling this outside. I'd guess there is going to be something like a warning being generated, and it is this that hiccups MPLAB....

[E_Blue]

How do you compile outside the MPLAB?
Are you using CCS IDE?

I use MPLAB because I mostly compile to debug the program.
_________________
Electric Blue

[Ttelmah]

If you have the IDE yes, you can use this, otherwise just use a command line compile.