How to import a library from Arduino to CCSC?

Jeetdesai · Joined: 05 Jul 2018 Posts: 18

I am using the CCSC compiler to write a code in a PIC18 MCU.

I would like to import a library from Arduino. Is it even possible to import a library from Arduino to CCSC? If yes, how can I do that?

The library I would like to import is 'U8g2'. I downloaded the library in Arduino via the Library Manager. But I wasn't able to locate any files on my hard disk with that name.

Thank You in advance.

PCM programmer · Joined: 06 Sep 2003 Posts: 21708

temtronic · Posted: Wed Jul 18, 2018 9:52 am

https://www.arduinolibraries.info/libraries/u8g2

Is what a quick google showed me....
seems to have several drivers in one package
As PCM P points out, post which display module you have since you probably don't need ALL of the u8g2 software.
Jay

Jeetdesai · Joined: 05 Jul 2018 Posts: 18

Jeetdesai · Joined: 05 Jul 2018 Posts: 18

My goal is to display Alphabets, Numbers and Shapes(rectangles, lines).

But even if I can get a code for lighting the entire screen[lighting every pixel], it would help me a lot.

Ttelmah · Joined: 11 Mar 2010 Posts: 19546

Drivers here:
<http://www.ccsinfo.com/forum/viewtopic.php?t=52861>
and using less RAM
<http://www.ccsinfo.com/forum/viewtopic.php?t=54453>

The SSD1309, is compatible with the SSD1306, _except_ be very aware of reset. I found I had to have a capacitor on the reset pin, which held it low for a significant time after power on, and then had a good delay before trying to initialise (500mSec). Have these running on several boards using the second driver pointed to above. Without the reset, got sort of 'semi random' odd wake up problems.

Jeetdesai · Joined: 05 Jul 2018 Posts: 18

Thank you for the quick response Ttelmah.

I noticed the first link uses the I2C protocol. I'd like to use the SPI protocol.
Would you recommend to use the '#use spi' command or 'setup_spi()' command?

Ttelmah · Joined: 11 Mar 2010 Posts: 19546

SPI uses more pins, hence most people with limited resources prefer the I2C. Even '3-wire SPI' needs four pins (D/C, CS, SDIN, SCLK). The drivers would need significant modifications to use SPI. No device address, hardware CS instead. However SPI is potentially a little faster. Even though 4-wire SPI is listed, reading is still not allowed using serial mode. There are two jumpers on the display that select SPI or I2C mode. It's up to you whether you want to just jumper the display for I2C and use the existing driver, or re-write the driver and use SPI.

#USE SPI

It is more powerful and more flexible.