CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
Debugging issues

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
Vamsi
Guest
Debugging issues
PostPosted: Tue Oct 23, 2007 4:19 pm     Reply with quote
Hi,

I have developed my own development board. I can program the device 18F4520 and everything works fine.

But when i try to enter debug mode. i get the following error.

Could not start target: The target was not halted after reset Check the target oscillator and MCLR. Make sure the target clock match the clock fuse and that the target is oscillating. Used View|Valid fuses to find the correct clock fuse

I only use MCLR, PGD,PGC and Supply. DO i have to use PGM or do anything to that pin?

Please comment on this if any one has come across the same issue.

THank you,
Vamsi
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Tue Oct 23, 2007 5:01 pm     Reply with quote
Look in the CCS ICD Diagnostics guide:
http://www.ccsinfo.com/downloads/ccs_icd_trblsht.pdf
For at Target Connect problem, start on page 9. Then maybe do page 10.
Humberto



Joined: 08 Sep 2003
Posts: 1215
Location: Buenos Aires, La Reina del Plata

View user's profile Send private message

PostPosted: Wed Oct 24, 2007 7:33 am     Reply with quote
Also, in the CCS Forum Index, there is a Hardware Forum where you will find a General
discussion about debuggers and programmers (ICD-S, ICD-U, Mach-X, etc) where you
will find a lot of info regarding this issue.


Humberto
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group